Technology And Equipment Tenders

The Following Services & Requirements Shall Be Considered:1. Investigation, Troubleshooting, Calibration, And Verification For Gckgc 6660 With Model Number (Gc 1000 Edw2hg-2bp-Pl-A1c1n-1500g3ca125n08n11nn/Fmy/Z, Style No S5.0492f700118). Our Concentr

Calibration Of Cable Lab Instruments

Seal Mechanical Shaft Sleeve Diameter 75mm Rotating Face Material Reaction Bonded Sic Stationary Face Material Carbon Pressur E Rating 18bar Style Split Arrangement Single Hardware Material 316 Qty.02

D'station Gtd9&10 Water Wash Pump Installaion For Two Unit

Bsdg Lube Oil And Engine Coolant Sample Collection & Analysis.(6 Units)Scope Of Work:1.Travel To Site (1 Day For 6 Units)2.Start T He Unit & Perform Ta1 Inspection3.Collect Engine Oil & Coolant L2 Samples4.Report Submission With Recommendation5.Sampl

Scope Of Work For Foam Sample Testingø#The Contractor Upon Receiving Po Should Schedule In Consultation Withdewa Engineerø#Request G Ate Pass To Enter Inside Dewa Plant For Discussionø#Collection Of Samples From Dewa Site (Total: 13 Samples)Ø#Foam Te

G Station Block 10 Desalination Unit 13 And 14 Seawater Pipe Rack Hydro Blasting, Coating And Nut Bolt Replacement Work

Additional Work Of De And Nde Bearing House Re-Sleeving On 200kw Motor.Motor Details 200kw 380v 50hz 366a 1485rpm Make: Weg

Kro Air Compressor Oil Cooler Replacement•#The Contractor Shall Remove The Old Oil Cooler And Install A Newplate Heat Exchanger Su Pplied By Dewa.•#The Contractor Shall Supply ,Fabricate And Install All Requiredmaterials (Heavy Duty Hoses Size 1.25 I

Relay Micom P521 Fast Feeder